MAKEMSI quickly and reliably creates MSI files in a non-programmatic way\Source CodeCommandsRegistryComment

---

The "RegistryComment" Command

This command can be used to set the comment for any registry entry which has not already been given one (the "Comment" parameter on the "Registry" command).

Comment searching is case insensitive. This command can be nested to any level.

The macro takes these parameters:

• Comment for This (positional)
  Not yet supported

  If no value is supplied for this parameter then the supplied comment becomes the default until a matching "/RegistryComment" command is encountered (block mode).

• Comment (required)
  This is the comment. An empty value would never be supplied unless you were wishing to reset default comments by using this command in block mode.

Please email me any feedback, additional information or corrections. See this page online (look for updates) MAKEMSI© is (C)opyright Dennis Bareis 2003-2008 (All rights reserved). Saturday May 28 2022 at 3:11pm Visit MAKEMSI's Home Page